2.4GHZ ANTENNA AMPLIFIER, BI-DIRECTIONAL 802.11g & 802.11b COMPATIBLE, AUTOMATIC GAIN CONTROL 500MW RP-TNCThe 24A500A Antenna Amp is a highly efficient and compact unit designed to increase the performance and range of any wireless device in the 2.4 GHz ISM band. Such devices include all Bluetooth, P2P, P2MP, 802.11b, 802.11b+, 802.11g, and 802.11b+g access points and wireless routers. In certain conditions the Antenna Amp is able to double the range of the wireless device. The Antenna Amp can extend the signal range and eliminate the use of an additional radio with its associated data line, power outlet, signal interference, and setup headaches. The Antenna Amp is the fast and easy way to extend your signal range in any environment.
The 24A500A Antenna Amp uses Time Division Duplex (TDD) technology. For Tx, we use a high-power, high-efficiency, linear amplifier MMIC manufactured on an advanced Gallium Arsenide Heterojunction Bipolar Transistor (HBT). Also, a power limit function regulates the output power level to an acceptable range. In WLAN applications, it produces a continuous output power of 500mW under the 802.11b spectral mask. For Rx, a low noise LNA provides greater receiving dynamic range and improves the overall quality of the incoming signal.
Frequency: 2.4-2.5GHz
Operating Mode: Bi-directional TDD (Time Division Duplex)
Transmitter Output Power: 500mW (27dBm)
Transmitter Input Power: 100mW (20dBm) max.
Receiver Input Power: -0.1mW (-10dBm) max.
Receiver Gain: 20dB
Switch Time: < 1s
Power Consumption: 6.5V @ 650mA
Connector: Right-Angle Reverse Polarity TNC Male
Diagnosis LED: PWR @ Green || TX @ Red || RX @ Yellow
Operating Temperature: -0C to +40C
Dimensions (L x W x H): 6.1 x 0.9 x 0.7in (155 x 22 x 19mm)
POWER SUPPLY
Input: 100-240VAC 50/60Hz 0.45A max.
Output: 6.5VDC 1A
INSTALLATION INSTRUCTIONS:
To avoid damage, please follow the install procedure below:
1. Unplug the AP/Router power supply from the wall.
2. Attach the 24A500A to the AP/Router.
3. Plug the AP/Router power supply back into the wall.
4. Plug the power supply into the 24A500A and the wall.
FCC NOTICE: To comply with FCC part 15 rules in the United States, this amplifier must only be used in systems that have been FCC certified. The system must also be professionally installed to ensure compliance with the Part 15 certification. It is the responsibility of the operator and professional installer to ensure that only certified systems are deployed in the United States. |
)
